Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Display stays black
#1
Hello, i have a problem with my Display, i think it is or was ok butt i can't activate it again.
I tried the stealth modus, no effect. I can vape but dosen't see any settings.
Upgrade the Firmware to 5.04, nothing happend to the display. Is there any option to restet the Firmware?
Did anyone know this problem?
Reply
#2
A few people have recently had have problems with the Joyetech Evic VTC mini having black screen problems or the screen won't turn on at all. Most of the time its not a hardware fault, but the device itself has accidentally been placed into Stealth mode. This makes your Evic VTC mini non functional and it will fail to turn on because it stops the buttons functioning. If you have attempted to take your Evic VTC mini out of stealth mode, then you will need to perhaps reflash the firmware onto it. Since the current software that is programmed into the chip could be damaged and probably may need to be reflashed with the latest firmware that is released.

How to turn off stealth mode on Evic VTC mini electronic cigarette:

1) Ensure that the mod has an 18650 battery fitted inside in.

2) Press the top circle button and the - buttons together.

3) The stealth mode will now be turned off fixing the no display you was getting on the screen before.

reset the firmware

Shut down with 5 clicks, pull the battery out for a few seconds, up to a minute if you want to be absolutely certain for sure, than pop battery back in.
Vaping is like a Tsunami
You cannot stop it with a law
Reply
#3
(02-25-2017, 12:40 AM)Tudi1980 Wrote:  Hello, i have a problem with my Display, i think it is or was ok butt i can't activate it again.
I tried the stealth modus, no effect. I can vape but dosen't see any settings.
Upgrade the Firmware to 5.04, nothing happend to the display. Is there any option to restet the Firmware?
Did anyone know this problem?

If the problem happened while updating the firmware you might have been half way through a custom image upload. re attach the device to the PC and start the firmware updater program, select update custom logo, pick a new custom image and click ok. You have to complete installing a custom bmp or the display stays black.
-=ϴ=-
Δ
|


Join us
Aliens are your friend!

Anti Spam Bot 18.x
Joyetech THE Premiere Electronic Cig. Manuf.
Reply


Bookmarks

Forum Jump:


Users browsing this thread: 1 Guest(s)