Joyetech Social
Settings help - Printable Version

+- Joyetech Social (http://social.joyetech.com)
+-- Forum: Question, Suggestion & Feedback (http://social.joyetech.com/forumdisplay.php?fid=3)
+--- Forum: Specific Products Discussion (http://social.joyetech.com/forumdisplay.php?fid=130)
+---- Forum: eVic-VTC Mini Series (http://social.joyetech.com/forumdisplay.php?fid=143)
+---- Thread: Settings help (/showthread.php?tid=2208)



Settings help - Arismac - 10-05-2015

Hi,

After I select Temp Ti and then a Fahrenheit value, when I press the fire button the display shows Power mode! Why?? Should it not show the Temp???

Thanx for assistance.


RE: Settings help - Smok_King - 10-09-2015

(10-05-2015, 07:48 PM)Arismac Wrote:  Hi,

After I select Temp Ti and then a Fahrenheit value, when I press the fire button the display shows Power mode! Why?? Should it not show the Temp???

Thanx for assistance.

Could be your Ti wire, shorting, coil legs not grounded to post tightly.
Check your build again.
And what brand Ti wire are you using? 微笑


RE: Settings help - Madboy - 10-09-2015

It could also be that you have not screwed the Atomizer in fully. When you screw it in ensure that it is tight.

Regards

Madboy